Vortec Truck Billet Power Steering Pulley – 5-Inch Diameter

This Dirty Dingo Motorsports pulley provides more clearance in tight engine compartments. Precision CNC machined from 6061-T6 billet aluminum, it is built for strength and balance.

Designed for 1987–2013 Vortec truck power steering pumps with a .748-inch shaft, this pulley uses a press-fit design and lines up with the factory truck accessory drive. A machined step on the back helps make installation easier.

Fitment Notes:

• Does not fit Trailblazer power steering pumps.

• Requires a belt 2 inches shorter than the belt used with the original pulley.

• A Pressure Reduction Kit may be needed to lower pump pressure.

View Installation Instructions

WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information go to www.p65warnings.ca.gov

ALUMINUM: Most of the aluminum alloys used today contain some level of lead, usually less than .1%. Lead is known to the state of California to cause cancer and reproductive harm. Most aluminum alloys are physiologically inert in their solid form, and the lead is contained within, however user-generated dust and/or fumes may pose a hazard if inhaled or ingested. Heating beyond a certain temperature may also provide avenues for exposure.

STEEL (steel bolts): Steel is an iron alloy with several metals including Nickel and Chromium. Both Nickel and Chromium are known to the State of California to cause cancer and reproductive harm, respectfully. This warning applies to stainless steels as well.