The Dirty Dingo passenger-side low mount A/C bracket kit is designed to install a Sanden SD7B10 mini compressor low on the passenger side of LS engines.
The bracket is laser cut and CNC bent from .250-inch cold rolled steel for strength and a precise fit. It comes finished in black texture powder coat and includes CNC-machined 6061-T6 billet aluminum spacers, Grade 8 zinc-coated hardware, and a belt tensioner.
This setup places the A/C compressor as close to the engine block as possible and runs the compressor on the inside 4-rib belt.
Fits:
-
LS Truck accessory spacing
-
Camaro, Firebird, and GTO accessory spacing
-
Gen III and Gen IV Corvette accessory spacing
-
All 1997-2015 Gen III and Gen IV LS engines
From the center of the crankshaft to the furthest outside point of the compressor setup, the measurement is approximately 10 5/8 inches.
Note: Belt is not included. Please check the installation instructions below for the correct belt size for your application.
Installation Instructions
Current Reviews: 1
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information go to www.p65warnings.ca.gov
ALUMINUM: Most of the aluminum alloys used today contain some level of lead, usually less than .1%. Lead is known to the state of California to cause cancer and reproductive harm. Most aluminum alloys are physiologically inert in their solid form, and the lead is contained within, however user-generated dust and/or fumes may pose a hazard if inhaled or ingested. Heating beyond a certain temperature may also provide avenues for exposure.
STEEL (steel bolts): Steel is an iron alloy with several metals including Nickel and Chromium. Both Nickel and Chromium are known to the State of California to cause cancer and reproductive harm, respectfully. This warning applies to stainless steels as well.
