Shopping Cart:  0 items
Quick Search

DD-LS-SR-ALT - LS Alternator Only Bracket Street Rod High Mount

All threaded holes in the block and cylinder head should cleaned and tapped with a thread chaser. All bolts being installed should be lubed with a light oil or anti-seize on the bolt threads before assembly.

Place the three counter sunk bolts through the front plate. Install the three "B" spacers, then the back plate, and finally the "A" spacers. Holding all the pieces toghether align the bolts and hand thread into the driver's cylinder head.



Install the alternator between the front and rear plate. Using the two socket head bolst with stainless washers under the head and the nut. Tighten all bolts to 28 ft lbs.

Install the idler pulley and tighten to 28 ft lbs.



Belt routing is as shown.


Belt sizes-


Small case alternator- Gates K060696

Large case alternator- Gates K060703


<< Offroad P-Pump < Back to List > LS Alternator Type 1 Power Steering Street Rod High Mount >>
GM Gen 3 Gen 4 LS Conversion LS Swap Mounts and Accessories