Shopping Cart:  0 items
Quick Search


1971-1990 GM B Body

If your vehicle did not start out as a Chevy V8, you will need to acquire Chevy V8 frame perches for a direct bolt in swap. However, we do not have a link for a reproduction frame perch. If you come across reproduction frame perches, let us know. 


Can't find used Chevy V8 frame perches for a 70-72 Impala on eBay? Check out this clamshell mount method.

 

1970-1972 Impala's used Short and Wide Early Style motor mounts. 1973 is when GM changed to Clamshells.

 

Choosing the Correct Conversion Mounts

*Goes over the differences of the Early Style (1955-72) and the Clamshell Style (1973-99)

 

1970-72 Impala with factory V8 Frame perches:

 

Short And Wide
 
OEM Part Numbers(Rubber):   3990914,   3960768,   6258154
 
Aftermarket Part Numbers(Rubber):   2142,   2285,   2267
 
Energy Suspension (Poly): 3.1114 Zinc, 3.1115 Chrome (G-Black, R-Red) 
 

OEM rubber motor mounts last much longer than aftermarkert rubber. Poly mounts essentially last a lifetime and don't need to be replaced.

 
 
 
 
 
 
LS GEN III/IV Conversion Mount Options:
 
 
 
(Starting out in raw non painted steel so make sure you paint them before the final install otherwise they will rust. They are also offered in black textured powdercoat for a small additional charge)
 
 
 
 
 
 
 
 
*Not compatible with low mount AC and passenger side motor mount requires a notch on the lower side 
 
 
 
 
LT GEN V Conversion Mount Options:
 
 
 
 
 
*Not compatible with low mount AC and passenger side motor mount requires a notch on the lower side
 
 
 
 
1973-1990 used the Clamshell Mounts. 
 
 
A- Clamshell Mount; B- Clamshell
 
 
 
If you you have the full Clamshell Style, with the Clamshell Mount and the Clamshell for this application, then you can use any of the conversion mounts listed above. The factory Clamshell is vehicle specific and side specific. They are not directly interchangeable with another vehicle. These are no longer available from the dealership. If you do not have the Clamshell, you can still use our EZ Mounts. They bolt directly to the engine and drop right over the factory clamshell mount. EZ Mounts do NOT require the factory Clamshell! You will often hear them referred to as the Dingo Sliders. 
 
 
 
 
LS EZ Mount
 
 
.
 
 
 
 
 
LT GEN V EZ Mounts
 
 
 
 
 
 
 
 
 

 


<<  < Back to List >  >>
GM Gen 3 Gen 4 LS Conversion LS Swap Mounts and Accessories